What is the technology?

In previous blog posts I have talked about how the first telephone works. In this post I am going to look at how newer phones work just to show the comparison between the old and new.

Similar to the first phone, the person speaks into the telephone, the sound waves created by their phone enter the mouthpiece. An electric current carries the sound to the telephone of the person you are talking to. the telephone consists of two main part: the transmitter and the receiver.

"The transmitter acts as an electric ear. It lies behind the mouthpiece of the phone. It has a 14 eardrum. The eardrum is a thin, round metal disk called a diaphragm. When a person talks into the phone, the sound waves strike the diaphragm and make it vibrate. The diaphragm vibrates at various speeds, depending on the variations in the air pressure caused by the varying tones of the speakers voice.

Behind the diaphragm lies a small cup filled with tiny grains of carbon. The diaphragm presses against these carbon grains. Low voltage electric current travels through the grains. This current comes from batteries at the telephone company. The pressure on the carbon grains varies as sound waves make the diaphragm vibrate. A loud sound causes the sound waves to push hard on the diaphragm. In turn, the diaphragm presses the grains tightly together. This action makes it easier for the electric current to travel through, and a large amount of electricity flows through the grains. When the sound is soft, the sound waves push lightly on the diaphragm. In turn, the diaphragm puts only a light pressure on the carbon grains. The grains are pressed together loosely. This makes it harder for the electric current to pass through them, and less current flows through the grains 
Thus, the pattern of the sound waves determines the pressure on the diaphragm. This pressure, in turn, regulates the pressure on the carbon grains. The crowded or loose grains cause the electric current to become stronger or weaker. The current copies the pattern of the sound waves and travels over a telephone wire to the receiver of another telephone. For more modern phones that have a telephone answering service, the sound wave is captured on a recording device which allows for the operator of the phone to playback at a later time.

The Receiver serves as an "electric mouth." Like a human voice, it has "vocal cords." The vocal cords of the receiver are a diaphragm. Two magnets located at the edge of the diaphragm cause it to vibrate. One of the magnets is a permanent magnet that constantly holds the diaphragm close to it. The other magnet is an electromagnet. It consists of a piece of iron with a coil of wire wound around it. When an electric current passes through the coil, the iron core becomes magnetized. The diaphragm is pulled toward the iron core and away from the permanent magnet. The pull of the electromagnet varies between strong and weak, depending on the variations in the current. Thus, the electromagnet controls the vibrations of the diaphragm in the receiver.

The electric current passing through the electromagnet becomes stronger or weaker according to the loud or soft sounds. This action causes the diaphragm to vibrate according to the speaker's speech pattern. As the diaphragm moves in and out, it pulls and pushes the air in front of it. The pressure on the air sets up sound waves that are the same as the ones sent into the transmitter. The sound waves strike the ear of the listener and he hears the words of the speaker."

https://www.antiquetelephonehistory.com/telworks.php